Mercedes-benz CL-Class 2011 Bedienungsanleitung PDF herunterladen (Seite 153)

Selecting points of interest using the

map

You can select points of interest that are

available in the selected (visible) map section.

X

To switch on navigation mode: press the

S function button once or twice.

X

To show the menu: press W the COMAND

controller.

X

Select Destination in the navigation

menu bar by turning cVd the COMAND

controller and press W to confirm.

X

Select Via Map by turning cVd the

COMAND controller and press W to

confirm.

If points of interest are available:

Depending on the map scale selected,

point of interest icons appear on the map.

The scale at which the icons are displayed

on the map varies according to the icon.

You can select the icons that COMAND will

display (Y page 168).

If there are points of interest, you will see

a message to this effect.

i

You also see this message if you have

selected the menu item No Symbols under

"Map display" (Y page 168).

Route guidance

General information

G

Warning

COMAND calculates the route to the

destination without taking into account the

following, for example:

R

Traffic lights

R

Stop and right-of-way signs

R

Lane merging

R

Parking or stopping prohibited areas

R

Other road and traffic rules and regulations

R

Narrow bridges

COMAND may give incorrect navigation

commands if the data in the digital map does

not correspond with the actual road/ traffic

situation. For example, if the traffic routing

has been changed or the direction of a one-

way road has been reversed.

For this reason, you must always observe

applicable road and traffic rules and

regulations during your journey. Road and

traffic rules and regulations always have

priority over the navigation commands

generated by the system.

Route guidance begins once a route has been

calculated (Y page 141).

COMAND guides you to your destination by

means of navigation commands in the form

of audible navigation announcements and

route guidance displays.

The route guidance displays can only be seen

if the display is switched to navigation mode.

If you do not follow the navigation

announcements or if you leave the calculated

route, COMAND automatically calculates a

new route to the destination.

If the digital map contains the corresponding

information, the following applies:

R

when selecting a route, COMAND tries to

avoid roads that only have limited access,

e.g. roads closed to through traffic and non-

residents.

R

roads that have time restrictions (e.g.

closed on Sundays and public holidays) are

avoided for route guidance.

Changing direction

Introduction

Changes of direction have three phases:

R

Preparation phase

R

Announcement phase

R

Change-of-direction phase

Navigation

151

COMAND

Z

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 479 480

Kommentare zu diesen Handbüchern

Keine Kommentare