Mercedes-benz CL-Class 2011 Bedienungsanleitung PDF herunterladen (Seite 474)

Model Engine

model

MB

Approval

CL 550 4MATIC

36

278 229.5

CL 600 275 229.5

CL 63 AMG 157

229.5

37

CL 65 AMG 275

229.5

37

i

MB Approval is stated on the containers.

Lubricant additives

!

Do not mix any lubricant additives with

the engine oil. This could damage the

engine. Damage resulting from the use of

such lubricant additives in the engine oil is

not covered by the Mercedes-Benz Limited

Warranty.

Engine oil viscosity

Viscosity describes the flow characteristics

of a fluid. If an engine oil has a high viscosity,

this means that it is thick; a low viscosity

means that it is thin.

Using the table below, make sure that the SAE

classification (viscosity) is sufficient for the

temperatures at which the vehicle is

operated. The low temperature

characteristics of engine oils can deteriorate

significantly, e.g by aging, soot and fuel

deposits. It is therefore recommended that

you carry out oil changes regularly using an

approved engine oil with the appropriate SAE

classification.

Refrigerant of the air-conditioning

system

The air-conditioning system is filled with

R134a refrigerant and a special PAG

lubricant.

!

Never use refrigerant R 12 (CFC) or

mineral lubricants. Otherwise, you could

damage the air-conditioning system.

Brake fluid

G

Warning!

The brake fluid constantly absorbs moisture

from the air; this lowers its boiling point.

If the boiling point of the brake fluid is too low,

vapor pockets may form in the brake system

when the brakes are applied hard (e.g. when

driving downhill). This would impair braking

efficiency.

You should have the brake fluid renewed at

regular intervals. The brake fluid change

intervals can be found in the Service Booklet.

Only use brake fluid approved by Mercedes-

Benz. Information about approved brake

fluids can be obtained from any authorized

Mercedes-Benz Center.

36

BlueEFFICIENCY.

37

Restriction: only SAE 0W-40 engine oils may be used.

472

Service products and capacities

Technical data

1 2 ... 469 470 471 472 473 474 475 476 477 478 479 480

Kommentare zu diesen Handbüchern

Keine Kommentare